Ventis HeroVent Flow Sensor Cable Replacement Guide

Quick answer

Replace the Ventis Medical HeroVent Flow Sensor Cable by disconnecting the old cable, inspecting connectors, and securely attaching the new one. This practical accessory supports HeroVent flow sensor setups in demanding environments.

Replacement steps

1. Power down and disconnect: Turn off the ventilator and disconnect it from any power source. Remove the old flow sensor cable by gently pulling the connector straight out from the sensor port and the ventilator unit. Common mistake: pulling at an angle can damage the port pins. Always pull straight.
2. Inspect connectors and cable: Check both ends of the old cable and the ventilator ports for dirt, corrosion, or bent pins. Clean the ports with a dry lint-free cloth if needed. Skip this step if the ports look clean; contamination is rare but can cause intermittent faults.
3. Attach the new cable: Align the connector keyway with the port and push firmly until fully seated. Connect the other end to the flow sensor. Power on the ventilator and verify the sensor reading appears within normal range. Common mistake: forcing the connector if it does not align easily. Check orientation before pressing.

Product facts

• Ventis Medical HeroVent Flow Sensor Cable: The Ventis Medical HeroVent Flow Sensor Cable is a practical accessory designed to support the functionality of compatible HeroVent systems, constructed for reliable performance in demanding medical or tactical environments. Using the correct replacement cable ensures consistent flow sensor data, which is critical for ventilator accuracy during patient care.